An In Vitro Study Evaluating The Effect Of Addition Of Carbon Nanotubes On Linear Dimensional Change Of Heat - Polymerized Denture Base Resin
Effect Of Carbon Nanotubes On Linear Dimensional Change Of Heat Polymerized Denture Base Resin
DOI:
https://doi.org/10.70284/njirm.v8i2.1205Keywords:
carbon nanotubes, acrylic, linear dimensional changeAbstract
Objective: To compare the linear dimensional change occurring between the antero-posterior and medio-lateral reference points marked on the heat- polymerized denture base resin between two groups formed with and without the addition of multi-walled carbon nanotubes in the posterior palatal seal region and mid palatine area on maxillary edentulous brass model. Method: Standard edentulous maxillary brass model, with 4 reference points [at incisive papilla (A), mid-palatal area in front of posterior palatal seal region (B), left and right tuberosities (C and D)] was made to fabricate a total of 10 denture bases. On the model, wax templates in the shape of posterior palatal seal (PPS) and mid palatine raphe were made to standardize the quantity of modified material incorporated in the PPS area and the mid palatine area i.e. acrylic mixed with 1 wt% of carbon nanotube. A control group with no incorporation of the modified material was also created. After denture base fabrication with incorporated modified material, the antero-posterior and the medio-lateral distance, between points A and B and points C and D, was measured with Digital Vernier Caliper and compared with the control group. Results: There was statistically significant difference found between the control and the incorporated carbon nanotube group when compared using unpaired t-test. Conclusion: Addition of carbon nanotubes in denture base acrylic resin showed significant linear dimensional change for this study. [Pankti N NJIRM 2017; 8(2):65-68]
References
2. Garoushi S, Yokoyama D, Shinya A, Valiittu P. Fiber reinforced composite resin pros-thesis to restore missing posterior teeth: A Case Report. Libyan J Med 2007;2:1-6.
3. Anusavice KJ. Philips’ science of dental materials. 10th ed. Philadelphia: WB Saunders; 1996. p. 249-257.
4. Cheng YY, Chow TW, Ladizesky NH. Denture base resin reinforced with high performance polyethylene fiber: water sorption and dimensional changes during denture immersion. J Macromol Sci-Phys 1993;32:433-481.
5. Mowade et al. effect of fiber reinforcement on impact strength of heat polymerized methyl polymethacrylate denture base resin: In viro study and SEM analysis. Int J Prosthodont 2012;4:30-36.
6. Wong DMS, Cheng LYY, Chow TW, Clark RKF. Effect of processing method on dimensional accuracy and water sorption of acrylic resin dentures. J Prosthet Dent 1999;81:300-304.
7. Collins PG, Avouris P. Nanotubes for electronics. J Scientific American 2000;283:62-69.
8. Anusavice, Phillips' Science of Dental Materials, 1st SouthAsia edition, Elsevier publications, 2013. Pg 474-497.
9. Turagam N, Mudrakola D P. Effect of micro-additions ofcarbon nanotubes to polymethylmethacrylate on reduction inpolymerization shrinkage, J Prosthodont 2013; 22: 105-11.
